Rubio Monocoat Smoke
Rubio Monocoat Smoke is a tannin-reactive product that is used on oak wood. It replicates the smoked look of wood without causing any toxic fumes or vapors.
- Traditional smoked look
- Accentuates the underlying character of the wood
- No toxic fumes
Good to know
This product is a pre-treatment and does not protect the wood. It has to be combined with Rubio Monocoat finishing products for protection.
How much will you need?
Please note: Calculations are estimates. Your results may vary based on species, water popping, sanding, etc...
| Spread Rate | 200-400 ft²/L |
|---|---|
| Dilutable | With Water |
| Shelf Life | 12 months |
| Dry Time | Varies. Test with a moisture meter before and after to ensure full dry. |
| Warning | Do not allow to freeze |
1. Sand the surface to 120/industry guidelines
2. Vacuum the surface
3. Shake Smoke well
4. Apply Smoke to the surface using an applicator pad or pump sprayer.
5. Be sure to keep a wet edge and apply enough product to ensure even coverage. Do not oversaturate the surface.
6. After 36 hours, neutralize using a rag damp with water.
7. Allow the surface to dry completely.
Sizing guide
Rubio Monocoat Smoke is a tannin-reactive product that is used on oak wood. It replicates the smoked look of wood without causing any toxic fumes or vapors.
- Traditional smoked look
- Accentuates the underlying character of the wood
- No toxic fumes
Good to know
This product is a pre-treatment and does not protect the wood. It has to be combined with Rubio Monocoat finishing products for protection.
How much will you need?
Please note: Calculations are estimates. Your results may vary based on species, water popping, sanding, etc...
| Spread Rate | 200-400 ft²/L |
|---|---|
| Dilutable | With Water |
| Shelf Life | 12 months |
| Dry Time | Varies. Test with a moisture meter before and after to ensure full dry. |
| Warning | Do not allow to freeze |
1. Sand the surface to 120/industry guidelines
2. Vacuum the surface
3. Shake Smoke well
4. Apply Smoke to the surface using an applicator pad or pump sprayer.
5. Be sure to keep a wet edge and apply enough product to ensure even coverage. Do not oversaturate the surface.
6. After 36 hours, neutralize using a rag damp with water.
7. Allow the surface to dry completely.